
A flange unit is a mounted bearing whose housing bolts to a surface perpendicular to the shaft, with the shaft passing through that surface. It is the answer wherever a shaft has to go through the side plate of a conveyor, a wall or a gearbox face, which is exactly where a pillow block cannot be used. The differences between the two-bolt, three-bolt and four-bolt forms are about the bolt pattern the mounting plate can accept and how much room there is around the shaft, rather than about the bearing inside, which is usually the same insert.
Also known as: flange bearings, flange mount bearings, flange bearing units, flanged bearing units
Series in this category
Related guides: Bearing selection guide, Bearing lubrication basics, Cross-reference help
| Specification | What it means |
|---|---|
| Shaft size | The bore of the insert carried in the flange housing, and the shaft it locks onto. |
| Bolt pattern | Two-bolt, three-bolt or four-bolt square — the arrangement of fixings the mounting plate must accept. |
| Bolt circle | The distance between fixing centers. Two flanges with the same bolt count can differ here and not interchange. |
| Pilot diameter | The register on the back face of a piloted flange that locates it concentrically in a machined bore. |
| Housing outside diameter | The overall size of the flange, which sets how much clearance it needs around the shaft opening. |
| Locking type | Setscrew, eccentric collar or concentric collar, chosen for the rotation direction and the load. |
The mounting plate, in almost every case. Four bolts spread load best and suit heavier duty, two-bolt diagonal flanges need the least room across the plate, and three-bolt brackets fit places a square pattern will not. On a replacement, the holes already drilled settle it.
One with a machined shoulder on the back of the housing that fits into a bore in the mounting plate. The register locates the bearing concentrically and carries some of the load, so the bolts are not relied on for position, which matters where the shaft has to run true to something behind the plate.
The mounting arrangement is better suited to it, because load into the plate is taken by the bolts in shear rather than by a base in bending, but the limit is still the insert and its locking device. Genuine sustained thrust needs a bearing selected for axial load.
Either, depending on how the machine was designed, and the choice changes how much shaft sticks out on each side. Establish which face the original was bolted to before ordering, because reversing it can leave too little shaft for the drive component on the other end.