
A bearing insert is the working half of a mounted bearing, sold on its own. It differs from an ordinary ball bearing in two ways that matter: the inner ring is extended so it grips a length of shaft and carries its own locking device, and the outer ring is ground to a sphere so it can swivel in a matching housing seat. That geometry is what lets mounted units sit on ordinary commercial shafting in frames that are not perfectly aligned. Buying the insert alone is the normal repair when the housing on the machine is undamaged.
Also known as: insert bearings, insert bearing, ball bearing inserts, wide inner ring bearings
Series in this category
Related guides: ER bearings explained, Bearing selection guide, Cross-reference help
| Specification | What it means |
|---|---|
| Shaft size | The bore of the inner ring, and the shaft diameter the insert locks onto. |
| Outer ring diameter | The spherical outside diameter that seats in the housing. It must match the housing seat, not just the shaft. |
| Outer ring width | How wide the outer ring is, which together with the diameter determines whether the insert fits the seat. |
| Locking type | Setscrew, eccentric collar, concentric collar or adapter sleeve — how the inner ring is fixed to the shaft. |
| Seal type | The seal or flinger arrangement protecting the balls, which is usually what decides life in contaminated duty. |
| Relubricatable | Whether the insert has a grease fitting for scheduled relubrication or is sealed and meant to be replaced. |
Usually yes, and it is the normal repair. The exception is a housing whose spherical seat has been worn or fretted, often because a previous insert was left to turn in it. Fitting a new insert into a damaged seat simply repeats the failure.
Two things. The inner ring is extended past the balls so it grips more shaft and can carry a setscrew or locking collar, and the outer ring is spherical instead of cylindrical so it can align itself in the housing. A standard deep groove bearing has neither feature.
No, and that is much of their appeal. They are made to run on ordinary commercial shafting within a fairly generous tolerance, which is why they suit fabricated conveyors and farm equipment where a precision shaft would be an unnecessary expense.
Two screws set apart around the inner ring grip the shaft at more than one point, which resists the insert creeping round the shaft under load far better than a single screw. Both should be tightened evenly, and both need checking if a unit starts to spin on its shaft.